How to configure the idChamp RS3 for Bluetooth-HID (keyboard) mode

To prepare your idChamp RS3 for Bluetooth HID (otherwise known as "keyboard mode"), follow the instructions below. Use the DIP switch table at the end of this page for reference.

1. Power off your RS3 and take it out of its enclosure by unscrewing the four screws, then lifting the lid.

2. Locate the DIP switch banks labeled "S2" and "S3" along the short edge opposite the micro-USB port.

3. Grab a paperclip or similarly shaped object (pens are NOT recommended) and flip the DIP switches up or down to match the image below. If you have problems loading the image, use the DIP switch table.

idChamp RS3 DIP switch bays S2 and S3 for HID mode

4. Locate the DIP switch banks labeled "S4" and "S5" along the long edge of your RS3. Flip the DIP switches up or down to match the image below. If you have problems loading the image, use the DIP switch table.

idChamp RS3 DIP switch bays S4 and S5 for HID mode

5. If you are planning to keep your RS3 in HID mode, you can put it back in its enclosure now.

6. Power on your RS3.


 

DIP Switch Orientation Table for HID Mode
  1 2 3 4 5 6
S2 Down Down Up Up Up Down
S3 Up Up Up Down    
S4 Down Down Down Down    
S5 Up Up Down Down Down Down

 

DIP Switch OrientationidChamp RS3-HSE diagram


Need help with a different DIP switch setting? Click on a Bluetooth mode below to view the instructions.