How to reconnect your scanner to SerialMagic Gears

This support article will walk you through how to disconnect and re-connect your Serialio Scanfob with SerialMagic Gears for Android.

1. Tap on the Serial Device Manager icon.

2. Tap on the "Disconnect" icon to the left of your Scanfob's name.

3. After disconnecting, tap on the "Reconnect" icon to the left of your Scanfob's name. It is in the same location as the "Disconnect" icon was.

Note: Make sure your Scanfob is discoverable (it will be flashing a blue LED). If it is not discoverable, hold down the small button for approximately three seconds (or until it starts to flash a blue LED.)

4. SerialMagic Gears will now reconnect to your Scanfob.