Select A Terminal Application
Before we begin, it's important that you make sure that you have a compatible terminal emulator installed on your computer. Here, at Serialio, we often use our product, JavaTerm. There are also a myriad of different terminal emulators (for Mac and Windows) that will do just fine. If you don't know where to start, we recommend YAT (Yet Another Terminal) for Windows and zTerm for Mac.
Configure The Terminal
As many of you likely know, serial devices and the respective application/hardware used to communicate with them must be configured to use the same serial communication settings. Because of this, we must make sure that the terminal emulator we use is configured to match the WiSnap's default serial communication settings. The table below shows the WiSnap's default configuration.
Configure the WiSnap Adapter
Once you have your terminal emulator configured, you're ready to setup your WiSnap adapter.
1. Power on the WiSnap adapter and plug it into your PC via an RS-232 to USB adapter cable [link to product].
2. When you plug the RS-232 to USB cable into your PC, Windows will assign a COM port number to the new USB connection. Use this COM port number to establish a connection to the WiSnap through the terminal emulator.
3. Once you have successfully established a connection to the WiSnap via the terminal, type $$$ into the terminal and press the ENTER key. This puts the WiSnap into command (CMD) mode. CMD mode allows you to configure the WiSnap for your unique use case or the environment.
5. Now the WiSnap is in CMD mode, refer to the WiSnap Command Reference & User Guide to configure the WiSnap's serial, network, and other settings. Afterward, make sure to restart the WiSnap by issuing the r,1 (restart) command to save the new configuration settings.